2 Sensor Beer Brew Thermostat Temperature Controller Cider Make Home Brewing Fermentation Curing

This dual-probe controller provides higher precision control compared to the single-probe controller. The single-probe controller has some limitations: If the probe is placed inside of the liquid, the outer layer of liquid might get too cold during cooling, because the liquid cools much slower than the air surrounding it. During heating, the outer layer of liquid might also get too hot. If the probe is placed in the chiller (outside of the tank), you may not know the true temperature of the beer inside because the fermentation is an exothermic process. This dual-probe controller is designed to solve this issue. For example, if you set the temperature of fermentation in 14C degrees, you can set the boundary (chiller temperature for probe 2) at 9C degrees. So the temperature in the chiller will never go lower than 9C degrees during the cooling process. In addition The controller equipped with high and low alarm set point that when the temperature reach to alarm set points, the controller start beeping and flashing.

• This controller uses two temperature probes for accurate home beer brewing system. L shape long probe is placed in the beer to accurately measure the liquid/beer temperature; the small probe is placed in the chiller (outside of the tank). This probe is to set the boundaries for heating and cooling, so that the chiller does not become too cold or too hot during the operation.
• Features: 2 relay and 2 sensors with 2 independent zones temperature controller (2 Heating mode, 2 Cooling mode or 1 Heating and 1 Cooling). 2 color display (red and blue) for each zone. Control temperature by setting the start and stop temperature setting value. High and Low Alarm function (buzzer and flash alarm). Refrigerating control output delay protection for Out1 and Out2. Temperature calibration for each sensor. Setting memory and factory default setting option.
• Temperature measuring range: -50-120 °C Accuracy: 0.1 Celsius Power consumption< 3W Sensors: Two NTC 10K with 1m wire length Power supply: AC 100-240V Output: 2 outputs with 10 Amp load
• 1-Stainless Steel L shape Sensor: Measurement range: -50 to 120 °C Cable length (L): 10 ft (3m) Sensing tip material: Waterproof Stainless Steel L shape sensor L shape dimensions: 6"x2" (150mm x 50mm) 2-Sensor Stainless Steel cylindrical: Measurement range: -50 to 120 °C Cable length (L): 3.3 ft (1m) Sensing tip material : water proof stainless steel sensor Sensing tip length x diameter: 20mm x 5mm Sensor type: Water proof
• High and Low Alarm function (buzzer and flash alarm). This Temperature Controller is an excellent, reliable, accurate and convenient multifunction device when you need to control the temperature precisely and constantly. It’s suitable for all equipment which need to control one zone or two zone (separately) for heating or cooling mode. Temp range -50 to 120 °C. It comes with two temperature sensors and manual.